Fellowes Powershred 8Cd Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
PAPER/CARD OR CD (8Cd only)
1
Continuous operation:
Up to 3-minute maximum
Plug in and set to
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-minutes will trigger
30-minute cool down period.
PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse ( ) Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date of
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
2
straight into paper
( )
entry and release
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
( ) *Apply oil across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
3 4
and unplug
3
or
Hold CD at edge, feed
into center of entry
and release (8Cd only)
3
Set to Reverse (
for 2-3 seconds
5 6
) Gently pull uncut
paper from paper and resume shredding
entry. Plug in
( )
)
Shredder doesn't start:
Make sure switch is in auto position (
Make sure safety lock is in unlock position.
Make sure head is on basket correctly.
Check for jam.
( )
Remove and empty basket.
).
3