GreenWorks Pro 60DPC10A Manual Del Operador página 5

EN
7 MAINTENANCE
7.1 CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or put the air flow in water.
• Clear the unwanted material out of the air vent with a
vacuum.
• Clean housing and the plastic components with a dry and
soft cloth.
Do not use strong solvents or detergents on the plastic
housing or components.
7.2 STOW THE MACHINE
• Remove the battery pack before you store the charger or
disconnect the charger.
8 TROUBLESHOOTING
PROBLEM
Charger doesn't
work. Charger
shows defective
mode. (LED
flashes Red)
Charger doesn't
work. Charger
shows evaluation
mode (LED indi-
cates Red solid
ON).
9 TECHNICAL DATA
Model 60DPC10A
Voltage 60 V
Input 120V AC 50/60Hz, 10A Max
Output 60V DC 10A
NOTE
IMPORTANT
POSSIBLE SOLUTION
CAUSE
Try to remove and
reinsert the battery
pack in the charg-
er.
Battery pack or
Try charging a dif-
charger is defective
ferent battery
or there is a bad
pack.
connection be-
tween the battery
Unplug the charg-
pack and charger.
er and wait until
the red LED goes
out, then reconnect
the plug to the
power supply.
Allow the battery
pack to reach nor-
mal temperature.
Battery pack is ei-
Charging will be-
ther too hot, or too
gin when the bat-
cold.
tery pack returns
to 3°C-47°C
(37°F-117°F).
English
30min. (1 Battery)/ 30min.
(2 Batteries)
37.5min. (1 Battery)/
37.5min. (2 Batteries)
45min. (1 Battery)/ 45min.
(2 Batteries)
Charge time
40min. (1 Battery)/ 48min.
(2 Batteries)
50min. (1 Battery)/ 60min.
(2 Batteries)
60min. (1 Battery)/ 72min.
(2 Batteries)
6
(use LB602
Battery)
(use LB6025
Battery)
(use LB603
Battery)
(use LB604
Battery)
(use LB605
Battery)
(use LB606
Battery)