Publicidad
Idiomas disponibles
Idiomas disponibles
LINE OUT OPERATION
1.
A set of Line Out jacks is included to allow audio from BT, USB, and PHONOGRAPH of
this turntable to play on an external device.
2.
Insert the audio cable (not included) into the turntable's Line Out socket.
3.
Operate the turntable as usual.
4.
In order to achieve the best sound, it is advised to set the turntable volume to a
minimum level.
5.
The turntable's audio will then be played back through the external device.
REPLACING THE STYLUS
It's suggested to replace the stylus after 400 hours of use.
Please follow the steps below to change the stylus:
1.
Lift the tone arm off the tone arm lock.
2.
At the front end of the tone arm, place the tip of your fingernail between the red stylus
holder and the black cartridge housing as shown. Press down on the red stylus holder
until it separates from the cartridge housing.
3.
Completely remove the red stylus holder with worn stylus and discard it.
4.
Place the new red stylus holder with stylus under the cartridge housing. First, press
upward on the back side of the stylus holder, and then press up on the front edge of the
stylus holder until it snaps into place on the cartridge housing.
CARE OF THE WOOD PANEL AND DUST COVER
1.
Care of the turntable is the same as any piece of furniture
2.
When the dust cover is dusty, you may wipe it using a soft, non-abrasive dust cloth.
3.
If the wood panel becomes smudged with fingerprints, you may use any good quality
commercial dusting and polishing spray cleaner
4.
We recommend spraying the cleaner on a cloth, not directly on the wooden panel.
8
Publicidad
