Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARE THE HOOD (
For ducted installation only:
Install both damper flaps inside the blower exhaust opening,
ensuring the pins are top oriented. See illustration below.
IMPORTANT!
P
ins on toP
HJ0225
'
)
cont
d
MODELS EWT1306SS • EWT1366SS
INSTALL THE WIRING
LOCATE
ELECTRICAL
OUTLET
WITHIN THESE
AREAS.
(Verify location
will not interfere
with duct,
mounting
brackets,
and flue.)
1. GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current. This
appliance is equipped with a cord with incorporated
grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and grounded.
NOTE:
A recessed "clock" outlet is recommended.
2. Position the electrical outlet within the space covered by
the decorative flue and where it will not interfere with the
round duct. Make sure the outlet does not interfere with the
mounting bracket fastening area, ductwork, or where the
decorative flue touches the wall.
Page 4
4"
12"
8. 8.
21"
Publicidad
