Publicidad
Idiomas disponibles
Idiomas disponibles
4. Remove the
grease filters
by pulling
down the
metal latch
tab and
tilting filters
downward to
remove.
HD1181
5. Attach non-duct collar to non-duct plenum using
(4) no. 8 x 3/8" pan head screws.
6. Measure
distance "A".
NON-DUCT PLENUM
This will be the
NON-DUCT COLLAR
length of the
extended flex
6" ALUMINUM
duct.
FLEX DUCT
7. Attach
aluminum
BLOWER
flexible duct
DISCHARGE
to the blower
OPENING
(without flaps)
discharge
opening with a
tie wrap.
8. Attach flexible
duct to non-
duct plenum
collar and
HD1260A
secure with tie wrap. Tape all joints with duct tape.
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN53SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN53SS flue extension.
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
9. Remove the upper flue from inside the lower flue. Install
the lower flue bracket to the lower flue using (2) flue
bracket screws (no. 8 x 3/8"). Make sure that the bracket is
positioned inside of the lower flue flanges - with the slots on
top. Carefully replace the upper flue inside the lower flue.
Remove protective plastic film covering the lower flue only.
HD1179
10. Carefully place both flues into the recessed area of of hood
top. Slightly push aside the upper flue to avoid any damage
while installing the lower flue to the hood top. Secure the
lower flue bracket to the wall using (2) no. 8 x 1½" mounting
screws.
11. Attach non-duct plenum with collar to upper flue using
(4) no. 8 x 3/8" pan head screws.
12. Hold hood up close to wall mounting location and plug
power cord into wall outlet.
SIDE VIEW
3-5/8"
HD1258
A
13. Align the hood and center it above the hood mounting bracket.
Gently lower the hood until it securely engages the bracket.
14. With the hood hanging in place, drill through both holes located
in the inside lower back of hood using a 5/16" drill bit. Insert the
included drywall anchors into the drilled holes (one for each hole).
Install (2) washers and (2) no. 8 x 1½" mounting screws through
the back of the
hood and into the
drywall anchors.
Verify
hood is centered
and
Tighten all screws
completely.
15. Attach (2) two non-duct recirculation filters to sides of
blower by aligning key lock slot and rotating until filters lock
into place.
For replacement non-duct recirculation filters - purchase
S99010494 (set of 2 filters).
16. Reinstall grease filters by aligning rear filter tabs with
slots in the hood. Pull down the metal latch tab, push filter
into position and release. Make sure filters are securely
engaged after installation.
UPPER
FLUE
17. Slide up the upper flue upward until it is aligned with its
upper flue mounting bracket. The bracket should be inside
the flue. Secure the upper flue to the upper flue mounting
bracket using (2) no. 8 x 3/8" mounting screws.
18. Remove protective plastic film covering the flue and the hood.
MODELS EWT1306SS • EWT1366SS
INSIDE BACK OF HOOD
HOLES LOCATION
that
the
leveled.
HO0388
UPPER FLUE MOUNTING BRACKET
HO0366
Page 9
MOTOR/BLOWER
ASSEMBLY
Ø 5/16" TYP.
Publicidad
