Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
CLEANING EXTERIOR
Turn off the water faucets after finishing the day's washing. This will shut off the water supply to your washer
and prevent the unlikely possibility of damage from escaping water. Leave the lid open to allow the inside of
your washer to dry out. Use a soft cloth to wipe up all detergent, bleach or other pills as they occur. Clean the
following as recommended: Control Panel - Clean with a soft, damp cloth. DO NOT use abrasive powders or
cleaning pads. DO NOT spray cleaners directly onto the panel.
CLEANING THE INTERIOR
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial residue
that may remain in your washer as a result of washing clothes.
Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent stains
on your washer or laundry .Hard water deposits may be removed, if needed. Use cleaners labeled "Washer safe".
CLEANING THE TUB
Run an Quick cycle with some bleach every month to clean the tub. This will also help to remove mold which may
occur inside the washer.
CLEANING LINT FILTER
There is a built-in lint filter in your washer. It can help to collect lint during washing cycle. It is suggested to clean
the lint filter every 10 cycles. Take it out and clean the filter with water. (Refer to Figure 18 and 19.) Then place it
back into the washer.
CLEANING PUMP FILTER
There is a built-in Pump filter in your washer. It can help to protect the
pump during washing cycle. It is suggested to clean the lint filter every
once every month. It is suggested to clean the pump filter once every
month. Take the filter out and clean it with water. Then place it back
into the washer.
Figure 18
Lint Filter
Pump Filter
19
Figure 19
Figure 20
Publicidad
