Publicidad
Idiomas disponibles
Idiomas disponibles
liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes causing
personal injury.
WarnInG:
hot lens. To reduce the risk of fire, keep away from combustible materials while in operation.
cautIon:
When not in use, place tool on its side on a stable surface where it
will not cause a tripping or falling hazard. Some tools with large battery packs will
stand upright on the battery pack but may be easily knocked over.
SyMBolS
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ....................... minutes
or DC ........... direct current
........................... Class II Construction
.......................... safety alert symbol
............Read instruction manual before use
................Use proper eye protection
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
recommended Minimum Wire Size for extension cords
total length of cord
25 ft.
50 ft.
7.6 m
15.2 m
Wire Size aWG
18
important Safety inStructionS for Battery chargerS
Save tHeSe InStructIonS: This manual contains important safety instructions for
battery chargers.
WarnInG:
charger, battery pack, and product using battery pack.
• Shock hazard. Do not allow any liquid to get inside charger.
• Burn hazard. To reduce the risk of injury, charge only designated Porter-caBle
batteries. Other types of batteries may burst causing personal injury and damage.
• Under certain conditions, with the charger plugged in to the power supply, the charger
can be shorted by foreign material. Foreign materials of a conductive nature such as,
but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should
be kept away from charger cavities. Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger before attempting to clean.
• Do not attempt to charge the battery pack with any chargers other than the ones
in this manual. The charger and battery pack are specifically designed to work together.
• these chargers are not intended for any uses other than charging designated
PORTER-CABLE rechargeable batteries. Any other uses may result in risk of fire,
electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• an extension cord must have adequate wire size (aWG or american Wire Gauge) for
safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. When using more than one extension to make up
the total length, be sure each individual extension contains at least the minimum wire size.
the lens gets very hot during use. To reduce the risk of burns, do not touch
75 ft.
22.9 m
18
16
Before using charger, read all instructions and cautionary markings on
A ......................... amperes
W ........................ watts
or AC ................. alternating current
n o ....................... no load speed
..........................earthing terminal
RPM or .../min .....revolutions or
..................Use proper respiratory protection
..................Use proper hearing protection
100 ft.
125 ft.
30.5 m
38.1 m
16
14
5
reciprocations per minute
150 ft.
175 ft.
45.7 m
53.3 m
14
12
Publicidad
