Publicidad
Idiomas disponibles
Idiomas disponibles
functIonal DeScrIPtIon
figure a
1. On/Off button
This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC681L, PCC682/PCC682L, PCC685L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC692/PCC692L, PCC695L
InStallatIon anD reMoval of tHe Battery Pack
to InStall Battery Pack: Insert battery pack into the flashlight until an audible click
is heard (figure B). Make sure battery pack is fully seated and fully latched into position.
to reMove Battery Pack: Depress the battery release button (3) as shown in figure
c and pull battery pack out of the flashlight.
oPeratInG InStructIonS
on/off Button
1. to turn the light on, press the on/off button (1) as shown in figure D.
2. to turn the light off, press the button again.
PIvotInG tHe leD lIGHt HouSInG - fIGure e
1. The LED light housing (2) can be pivoted by rasing and lowering it to different
positions within the 180 degree pivot range.
trouBleSHootInG
ProBleM
• Light will not illuminate.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly. • Battery pack has reached its
For assistance with your product, visit our website at www.portercable.com for a list of service
centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
tHe rBrc™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the Li-Ion battery (or
battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of
its useful life have already been paid by PORTER-CABLE.
RBRC™ in cooperation with PORTER-CABLE and other battery users, has established
programs in the United States to facilitate the collection of spent Li-Ion batteries.
Help protect our environment and conserve natural resources by returning the
spent Li-Ion battery to an authorized PORTER-CABLE service center or to your
local retailer for recycling. You may also contact your local recycling center for
2. Pivoting LED light housing
PoSSIBle cauSe
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature • Move charger and battery
too hot or too cold.
maximum thermal limit.
• Out of charge. ( to
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
8
PoSSIBle SolutIon
• Check battery pack
installation.
• Check battery pack
charging requirements.
charger until LED illuminates.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
pack to a surrounding air
temperature of above
40 degrees F (4,5°C) or
below 105 degrees F
(+40,5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.
Publicidad
