Publicidad
Wood Stud Installation
Determine Mounting Height
CAUTION: Before proceeding with this installation consult your TV product guide for manufacturer
recommendations on choosing a mounting location that will ensure optimum TV performance. Location
considerations might include: TV height and viewing angle - based on height and distance of seating,
room dimensions and size of TV; access to power outlets; cable connections for speakers and other devices;
protection from glare and heat, (windows, lamps, fireplace, air ducts) and vibration. Please take into account
that this product is being installed in it's highest position. Your TV will only be able to be lowered from it's
installed position.
a
c
Insert wall anchors into
wall (not wood stud).
1
Drill 1/2" diameter hole. Hold
2
1/2" diameter
metal channel at alongside
plastic straps and slide channel
through hole.
Taladre un agujero de 1/2 pulg.
1/2 pulg. de dia.
de diámetro. Sostenga la
canaleta metálica a lo largo de
las tiras plásticas y deslícela a
ter hole. Hold
Hold ends of straps between
3
través del agujero.
at alongside
thumb and fore nger and
nd slide channel
pull toward you until channel
rests ush behind wall. Slide
plastic cap along straps with
ero de 1/2 pulg.
other hand until ange of cap
ostenga la
is ush with wall.
ca a lo largo de
as y deslícela a
Sostenga las puntas de las
straps between
Snap straps at wall by pushing
ero.
tiras entre sus dedos pulgar e
re nger and
side to side, snapping o
índice y tire de ellas hacia
ou until channel
straps level with ange of cap.
usted hasta que la canaleta
Drill 4 holes: 2 at stud and 2 at solid wall using appropriate bits.
b
Place template
on wall so
that it covers
at least one
wood stud
and mark the
mounting
holes with a
pencil.
d
2
1/2" diameter
1/2 pulg. de dia.
3
Hold ends of straps between
thumb and fore nger and
pull toward you until channel
rests ush behind wall. Slide
plastic cap along straps with
other hand until ange of cap
is ush with wall.
Sostenga las puntas de las
Snap straps at wall by pushing
tiras entre sus dedos pulgar e
side to side, snapping o
índice y tire de ellas hacia
straps level with ange of cap.
usted hasta que la canaleta
quede al ras detrás de la
Rompe las tiras en la pared
pared. Con la otra mano,
empujándolas de lado a lado,
deslice la tapa plástica a lo
soltando las tiras que queden
largo de las tiras hasta que la
al nivel de la brida de la tapa.
brida de la tapa quede al ras
de la pared.
Install top two screws leaving about a 1/2"
of room between the head of the screw and
the wall.
PN: 888-61-041-W-02 revF
7/32"
80mm
3
W-C
Snap straps at wall by pushing
side to side, snapping o
W-A
straps level with ange of cap.
Rompe las tiras en la pared
empujándolas de lado a lado,
soltando las tiras que queden
al nivel de la brida de la tapa.
1/2"
13
Publicidad
