Amprobe CO2 Meter Manual De Uso página 13

Setup
The advanced setup mode lets you customize your meter.
2 types parameter are available.
P1.0: CO2 alarm threshold setting
P3.0: Temperature unit setting
P1.0 CO2 alarm threshold setting
Hold down "POWER/SET" under normal mode for more
than 1 sec to enter set up mode. To exit setup, press
"CAL/ESC" in P1.0 or P3.0.
When entering setup mode, P1.0 and "AL" are displayed
on the LCD (Fig.3). Press "ENTER" to go into P1.1 for
setting CO2 alarm threshold. The current set value will
be blinking on LCD (Fig.4). Press "p"to increase the
value or "q"to decrease. Each press tunes 100 ppm and
the alarm range is from 100 to 9900ppm. When the
preferred alarm value is set, press "ENTER" to save the
setting or "ESC" without saving and return to P1.0.
Fig.3 Fig.4
P3.0: Temperature unit setting
Press "p"or "q"in P1.0 to access P3.0 for setting up
temperature scale. Press "ENTER" and it goes into P3.1
with blinking °C or °F current set on the lower left
display. To switch °C or °F, press "p"or "q. Then press
"ENTER" to save the setting or "ESC" without saving and
return to P3.0.
6