Publicidad
Idiomas disponibles
Idiomas disponibles
30
1/4-20 X 1 1/2 Phillips
Truss Head Screw
(Qty. 2)
Note: If hinge (#18) is positioned as shown in Detail N, you will have to rotate the hinge
to the position shown in Detail O. DO NOT unscrew the hinge, you can rotate the hinge
without unscrewing it from the table.
21. Attach Hinges (#18) to Strut Tubes (#17) as shown in Figure 14 & Detail O. With
hinge positioned as shown, align hole in hinge with hole in Strut Tube and attach with
¼" Screw (#30), Plastic Washer (#38) and Locknut (#34). Plastic Washer (#38) goes
between Strut Tube and Hinge. Tighten nut securely. Repeat for other Hinge.
CAUTION: Hinges must be positioned exactly as shown or table will not
operate correctly and could be damaged.
ATTENTION: If hinge is positioned as
shown here (Detail N), Rotate the hinge as
shown in Detail O. Do not take hinge off.
Elbow
Incorrect position
of hinge with elbow
pointing up.
CAUTION: Position hinges exactly as
shown in Detail O or table will not
operate correctly and could be damaged.
Detail O
30
18
Correct position
of hinge with elbow pointing down
In the correct position Hinge #18
will look like a "V" when attached
to Strut Tube (#17).
HARDWARE NEEDED
34
1/4-20 Locknut
(Qty. 2)
Detail N
17
34
30
38
17
Elbow
Hinge Assembly
with "elbow"
pointing down.
38
1/4" Plastic
Washer
(Qty. 2)
Figure
17
38
18
17
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY DAMAGE.
14
17
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
34
18
Hinge Assembly
with "elbow"
pointing down.
30
38
Publicidad
