Publicidad
Idiomas disponibles
Idiomas disponibles
24
1/4-20 X 2 1/2" Hex Head Bolt
22. Secure U-support tube (#21) to Strut Tubes (#17) with two Screws (#5) as
shown in Figure 15. Align holes in U-support with holes in Strut Tubes
and thread screw (#5) into hole in Strut Tube (#17). Tighten screws all the
way but be careful not to over tighten as you could strip threads on screws.
23. Attach Linkages (#16) to Leg (#19) as shown in Figure 15. Pivot Leg
(#19) out from the table top and pivot both linkages (#16) up and align
hole in Linkage with hole in Leg (#19). Attach Linkage (#16) to Leg (#19)
using Hex Head Bolt (#24), Spacer (#37) and Locknut (#34). Spacer
(#37) goes between Linkage and Leg. Attach other Linkage to Leg
the same way. Tighten nuts securely.
24. With at least two adults, repeat Steps 20-23
for other table top assembly.
Figure
15
16
(Qty. 2)
19
24
16
HARDWARE NEEDED
34
37
1/4-20 Locknut
(Qty. 2)
34
34
37
21
17
5
17
Note:
Make sure to
.
install screw #5
18
5
3/8" Long Spacer
(Qty. 2)
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD
BE KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY
DAMAGE.
19
24
Spacer goes
between Linkage Arm
(#16) and Leg (#19)
5
16
Note:
install screw #5
#8 X 9/16
Screw
(Qty. 2)
37
Make sure to
.
Publicidad
