Publicidad
Idiomas disponibles
Idiomas disponibles
Phase 3
(Fig. C)
Connect the Range Hood to the external exhaust (H).
(1) Measure the height J.
(2) Cut the pipe (K) to the required length.
(3) Carefully insert the pipe (K) in the motor fitting (L).
Note :
- The exhaust conveyor that protrudes from the upper part of the Range Hood must be connected with the pipe that conducts
the fumes and vapours in an external output.
- The fumes and vapours are discharged outside through the exhaust pipe.
To this end, the Range Hood outlet fitting must be connected via a pipe, to an external output.
- The diameter of the fume discharge duct must be no smaller than the Range Hood connection.
- The outlet pipe must have a diameter not less than that of the Range Hood fitting.
- The outlet pipe must have :
• A slight slope downwards (drop) in the horizontal sections to prevent condensation from flowing back into the motor.
• The duct must be installed not to bend it in the immediate vicinity of the discharge hole. Otherwise, the return valve will get
stuck with the duct, and will not work for the exhaust properly.
• Reduce curves to the bare minimum, and check that the length of the ducts is also the bare minimum.
• You are required to insulate the pipes if it passes through cold environments.
C
(2)
K
K
Ø8"
(Ø203 mm)
H
(3)
L
J
(1)
15
Publicidad
