Publicidad
Idiomas disponibles
Idiomas disponibles
Phase 4
(Fig. D, E)
(1) Fasten the pipe (K) to the Range Hood body with the 3 screws (V3 Ø4.2x12.5).
(2) Set up the electric connection to power the Range Hood only after having disconnected the main power supply switch
and complied with current regulations.
Note :
- The electrical system to which the Range Hood is to be connected must be in accordance with local standards and supplied
with earthed connection in compliance with safety regulations in the country of use.
It must also comply with local standards regarding radio antistatic properties.
- Before connecting the Range Hood to the electrical mains power supply, check that : the power supply plug and cable do
not come into contact with temperatures exceeding 158 °F (70 °C);
- Check that the relief valve and the electrical system are able to support the load of the appliance (see the technical
specifications displayed on the rated plate in the Range Hood).
D
(1)
K
16
K
V3
3 - Ø4.2x12.5
3 - Ø4.2x12.5
E
(2)
(2)
Publicidad
