Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the protector
WARNING:
Never use the tool without the
guard or with the guard improperly installed.
Failure to do so can cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION:
Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the cutting tool.
NOTE: The type of the cutting tool(s) supplied as the stan-
dard accessory varies depending on the countries. The cut-
ting tool is not included in some specifications of the model.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
4
5
2
► 1. Nylon cutting head 2. Spindle 3. Hex wrench
4. Loosen 5. Tighten
1.
Insert the hex wrench through the hole in the tool
head to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
1
3
1
2.
Place the nylon cutting head onto the spindle and
tighten it securely by hand.
3.
Remove the hex wrench from the tool head.
To remove the nylon cutting head, follow the installation
procedures in reverse.
OPERATION
Attaching the shoulder harness
CAUTION:
nation of the backpack-type power supply such
as portable power pack, do not use the shoulder
harness included in the tool package, but use the
hanging band recommended by Makita.
If you put on the shoulder harness included in the
tool package and the shoulder harness of the back-
pack-type power supply at the same time, removing
the tool or backpack-type power supply is difficult in
case of an emergency, and it may cause an accident
or injury. For the recommended hanging band, ask
Makita Authorized Service Centers.
CAUTION:
attached to the tool. Before operation, adjust the shoul-
der harness according to the user size to prevent fatigue.
CAUTION:
the shoulder harness is properly attached to the
hanger on the tool.
1.
Wear the shoulder harness on your left shoulder.
2.
Clasp the hook on the shoulder harness to tool's hanger.
3
1
► 1. Hook 2. Hanger
12 ENGLISH
When you use the tool in combi-
Always use the shoulder harness
Before operation, make sure that
2
Publicidad
