hillvert HT-IRI-08 Manual De Instrucciones página 20

2. Water connector adapter (¾-inch)
3. Water connector (1 inch)
4. Water filter
5. Display
6. Function selection knob (timer)
7. Selected function LED
8. Value increase button (+)
9. Value decrease button (-)
10. Left (L)/Right (R) valve selection button
11. Manual control activation/deactivation button
12. Control panel cover
13. Connection socket for moisture/rain sensor (optional)
14. Male end of a hose quick disconnect
3.2.
Preparing for use
APPLIANCE LOCATION
Keep the device away from any hot surfaces. The device should always be used
out of the reach of children and people with reduced psychological, sensory and
mental capacity.
ASSEMBLING THE APPLIANCE
Pull out the battery drawer at the back of the device and install 2 batteries
(LR6/AA), paying attention to their correct polarity - as marked on the bottom of
the drawer. Push the drawer back into the device.
PLEASE NOTE: do not use rechargeable batteries for the power supply!
After you install the batteries, a clock will appear on the display. Before connecting
the device to the tap, turn the function selector knob to OFF. When connecting the
device to the water installation, do not forget about the water filter in the
connector (see the picture below). Finally, connect the hose to the respective
connector on the bottom of the device.