Publicidad
Idiomas disponibles
Idiomas disponibles
3. Attach four Strut Tubes (#4) to Caster Beam Assembly
with four Carriage Bolts (#10) and four Locknuts (#14)
as shown in FIGURE 3. Tighten nuts snug but DO NOT
over tighten.
Hardware Needed:
4 pcs - #10 Carriage Bolt
4 pcs - #14 Locknut
Parts Needed:
4 pcs - #4 Strut Tube
4
10
14
NOTE:
Snug, but DO NOT over-tighten these four pivot points.
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
AND SAFETY INSTRUCTIONS CAREFULLY.
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
5
AT LEAST
Figure 3
Publicidad
