Publicidad
Idiomas disponibles
Idiomas disponibles
7. Attach U-Support (#3) and Strut Tubes (#4) using two Screws (#15) as shown in FIGURE 7.
Note: If hinge (#5) is positioned as shown in DETAIL E, you will have to rotate the hinge to the position shown in
Detail F. DO NOT unscrew the hinge, you can rotate the hinge without unscrewing it from the table. If you want to
see a video on how to position Hinge (#5) go to:
8. Attach Long Hinge & Mounting Bracket Assemblies (#5) to Strut Tubes (#4) using two Bolts (#12), two Spacers (#11),
two Flat Plastic Washers (#13) and two LockNuts (#14) as shown in FIGURE 7 and DETAIL F.
Tighten Nuts snug, but DO NOT OVERTIGHTEN, hinges must pivot.
9. Attach two Corner Protectors (#25) to Top Assembly using four Screws (#15) with four Washers (#26) as shown in FIGURE 7.
Repeat for other Table Top.
Hardware Needed:
2 pcs - #11 Spacer
2 pcs - #12 Phillips Rd. Hd. Bolt
2 pcs - #13 Flat Plastic Washer
2 pcs - #14 LockNut
6 pcs - #15 Phillips Rd. Hd. Screw
4 pcs - #26 Washer
ATTENTION: If hinge is positioned as shown
below (DETAIL E), rotate the hinge as shown in
DETAIL F. Do not take hinge off.
INCORRECT POSITION OF HINGE
CAUTION: Position hinges exactly as
shown in DETAIL F or table will not
operate correctly and could be damaged.
CORRECT POSITION OF HINGE
In the correct position Hinge (#5) will look
like a "V" when attached to Strut Tube (#4).
http://www.escaladesports.com/customer-service/videos.html
Part Needed:
2 pcs - #25 Corner Protector
9
DO NOT OPEN THE TABLE TO PLAYING POSITION
UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE
TABLE STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.
NOTE: Tighten screws snug,
but do not overtighten, causing
screws to strip in metal tube.
Figure 7
Publicidad
