Publicidad
Idiomas disponibles
Idiomas disponibles
5. A) Attach one LH short Hinge & Mounting Bracket Assembly (#18) using four Screws (#15) as shown
in DETAIL C. Attach one RH short Hinge & Mounting Bracket Assembly (#6) using four Screws
(#15) as shown in FIGURE 5.
using eight Screws (#15) as shown in DETAIL D & FIGURE 5.
B) Attach LH short Hinge & Mounting Bracket Assembly (#18) and RH short Hinge & Mounting Bracket
Assembly (#6) to U-Leg (#1) using two Bolts (#17) with four Flat Plastic Washers (#13) and two
Locknuts (#19) as shown in FIGURE 5 and DETAIL C. DO NOT OVERTIGHTEN hinge must pivot.
REPEAT STEPS 4-5 ON THE OTHER ALUMINUM TOP ASSEMBLY.
CAUTION: Hinges must be positioned
exactly as shown or table will not operate
correctly and could be damaged.
Do not overtighten nuts, hinge must pivot.
NOTE: Hinge
must operate
as shown.
NOTE: Tighten screws snug, but
do not overtighten, causing screws
to strip in metal tube.
Attach two Long Hinge & Mounting Bracket Assemblies (#5)
Parts Needed:
1 pc - #6 RH short Hinge & Mounting Bracket Assembly
1 pc - #18 LH short Hinge & Mounting Bracket Assembly
2 pcs - #5 Long Hinge & Mounting Bracket Assembly
Hardware Needed:
16 pcs - #15 Phillips Rd. Hd. Screw
2 pcs - #17 Phillips Rd. Hd. Bolt
4 pcs - #13 Flat Plastic Washer
2 pcs - #19 Locknut
7
Figure 5
Publicidad
