Publicidad
10. Remove the
assembly-inner
11. Remove the
system
board.
NOTA:
The system board can be removed with the heat sink attached in order to simplify the procedure and preserve the
thermal bond between the system board and heat sink.
12. Remove the
display
assembly.
13. Remove the
smart-card
14. Remove the
fingerprint
Sobre esta tarea
NOTA:
For models shipped with WLAN card only, the dummy SIM-card slot filler is a separate service part and is not included with
replacement palm rest. As a result, the dummy SIM-card slot filler must be removed and then reinstalled when replacing the palm-rest
assembly.
The following image indicates the dummy SIM-card slot filler and provides a visual representation of the dummy SIM-card slot filler
removal procedure.
Pasos
1. Using a scribe, push the dummy SIM-card slot filler from the top side of the palm-rest assembly.
2. Gently lift the dummy SIM-card slot filler out of the palm-rest assembly.
Instalación de la pieza de relleno de la ranura de tarjeta SIM ficticia
Requisitos previos
Si va a reemplazar un componente, quite el componente necesario antes de realizar el procedimiento de instalación.
Sobre esta tarea
En la imagen a continuación, se indica la ubicación de la pieza de relleno de la ranura de tarjeta SIM ficticia y se proporciona una
representación visual del procedimiento de instalación de la pieza de relleno de la ranura de tarjeta SIM ficticia.
126
Extracción e instalación de unidades reemplazables en campo (FRU)
frame.
reader.
reader, if applicable.
Publicidad
