Hart HLCG02 Manual Del Operador página 4

ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use
of a product that is not properly and completely as-
sembled or with damaged or missing parts could result
in serious personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging HART 40 Volt lithium-ion batteries
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Return the charger and battery to your nearest
service center for service or replacement.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
KEY HOLE HANGER
To mount the charger, only use the key hole hanging feature.
To mount charger, screws should be installed so that the
center distance is 2 5/8 in. (66 mm).
WARNING:
Do not attempt to modify this product or create ac-
cessories or attachments not recommended for use
with this product. Any such alteration or modification
is misuse and could result in a hazardous condition
leading to possible serious personal injury.
CHARGING
See Figure 1, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time varies and is dependent upon the amp hour
capacity of battery pack.
 Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Latches should snap into place to ensure charger is
correctly connected.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
 The green LED will flash while the battery pack is charging.
NOTE: If the LED turns red and begins a pattern of two
quick blinks, the charger has detected an error. See LED
Functions for Battery Charging details.
 After charging is complete, the charger's green LED will
be solid green.
NOTE: The LED will turn off 10 minutes after charging
has been completed.
 To remove the battery pack from the charger, depress
latches and slide the battery pack out of the charger.
 Fan may make a slight humming noise when the battery
is charging.
4 – English