Publicidad
Idiomas disponibles
Idiomas disponibles
Edging Along A Curb (If equipped)
The right rear wheel of the edger can be lowered into one of five positions to
ease the task of edging along a curb. To adjust the height of curb wheel, proceed
as follows:
1.
Lower the right rear wheel by moving the curb height adjustment lever
slightly to the left. See Figure 10.
Curb Height
Adjustment
Lever
3
2
2.
Pivot the right rear wheel into an applicable position in relation to the height
of the curb to be edged along.
3.
Release the curb height adjustment lever to lock the wheel in position.
OPERATION
1
Figure 10
Beveling (If equipped)
In order to achieve a bevelled edge, set the bevel adjustment lever (refer to
Assembly Section) in the first (left hand) or third (right hand) notch to place the
edger blade in position for beveling. See Figure 11.
Right-Hand Position
10
Left-Hand Position
Figure 11
Publicidad
