NightStick Intrant XPP-5566 Manual De Instrucciones

Instruction Manual
Intrant
US PATENT 9,713,217 & 10,119,663
THE XPP-5566 IS APPROVED FOR USE
Bayco Products, Inc.
640 S. Sanden Blvd., Wylie, TX 75098
Ex ia FLASHLIGHT FOR USE IN HAZARDOUS LOCATIONS
For use with Bayco Li-ion Battery Pack 5568-BATT or
5566-CARRIER with 3 AA Energizer Type EN91 or E91
E 467756
CLASS I DIV 1 GRPS A-D T4
ID 4003544
CLASS II & III DIV1 GRPS E-G T135°C
CLASS I ZONE 0 AEx ia IIC T4 Ga
ELECTRICAL SAFETY
INTRINSICALLY SAFE
I M1 Ex ia op is I Ma
SECURITE INTRINSEQUE
II 1 G Ex ia op is IIC T4 Ga
2575
Control Drawing: 5568-CERT-DWG1-03
WARNINGS - INTRINSICALLY SAFE
y WARNING: Use only the approved Nightstick 5568-BATT Lithium-ion rechargeable
battery pack or the approved non-rechargeable batteries listed in special condition of use
in bullet 4.
y WARNING: To prevent ignition of a hazardous atmosphere, do not open any part or
attempt to exchange any of the supplied battery packs while in the hazardous environment.
This task must ONLY be performed in an area known to be non-hazardous.
y Warning: To prevent ignition of a hazardous atmosphere, the approved Nightstick 5568-
BATT Lithium-ion rechargeable battery pack must only be charged in an area known to
be non-hazardous.
y WARNING: When using non-rechargeable batteries in the Nightstick 5566-CARRIER,
use only Energizer EN91 or Energizer E91 batteries.
y WARNING: To prevent ignition of a hazardous atmosphere, non-rechargeable AA
batteries must only be changed in an area known to be non-hazardous.
y WARNING: To reduce the risk of explosion, do not mix new non-rechargeable batteries
with used non-rechargeable batteries, or mix non-rechargeable batteries from different
manufacturers.
y WARNING: Substitution of components may impair intrinsic safety.
y WARNING: This equipment could be susceptible to electrostatic charge as it measured
capacitance of 4 pF from external metal parts to earth.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
y For personal safety, always confirm the rating of any known hazardous or potentially
hazardous location where the Angle Light is to be used.
y Only devices directly connected to apparatus complying with the IEC 60950 series are
allowed.
STROBE WARNING
Exposure to strobing lights may cause dizziness, disorientation, and nausea. A very small
percentage of people suffer from photosensitive epilepsy and may experience seizures or
blackouts triggered by strobing lights. For more information from the Epilepsy Foundation about
photosensitivity and seizures, please visit www.epilepsy.com. Anyone who has had symptoms
linked to this condition should consult a doctor before using this product.
POWERING THE XPP-5566
The XPP-5566 Intrinsically Safe Light is powered by the Nightstick 5566-CARRIER Non-
Rechargeable Battery Carrier and 3 - AA Energizer EN91 or Energizer E91 Batteries. The
5566 is sold only with a primary battery pack. It can be made rechargeable if a secondary
battery pack kit is purchased.
WARNING: Do not use any other type of non-rechargeable battery with this light.
WARNING: Do not use rechargeable AA batteries with this light.
5566-CARRIER NON-RECHARGEABLE BATTERY CARRIER
WARNING: The Nightstick 5566-CARRIER Non-Rechargeable Battery Carrier is a
proprietary shape and design and will only fit in the XPP-5562, XPR-5564, XPP-5566
and XPR-5568 Angle Lights. Do not attempt to use this battery pack in any other light.
Do not attempt to use any other battery pack in this light.
y The Nightstick 5566-CARRIER Non-Rechargeable Battery Carrier is designed to fit 3
AA batteries. In order to maintain the XPP-5566's Intrinsically Safe Permissible rating, the
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
XPP-5566
®
XPP-5566
batteries only
Ex ia op is I Ma
Ex ia op is IIC T4 Ga
DEMKO 17 ATEX 1927
UL22UKEX2426
IECEx UL 17.0082
-20ºC ≤ Tamb ≤ +40ºC
1.5V/Cell Alkaline
3.7V/Cell Li-ion
0359
IP-67
22-AV4BO-0250X
Um: 10V
For Battery Charger Connection see Instruction
Manual Drawing: 5562-68-MECH-DWG1-09
only AA batteries certified for use with this light are the Energizer EN91 or Energizer E91.
y Do not attempt to use any other brand or model of AA batteries with this light.
y Do not attempt to use any type of rechargeable AA batteries with this light.
Removing the Non-Rechargeable Battery Carrier
WARNING: To prevent ignition of a hazardous atmosphere, do not open the battery
compartment in the hazardous environment. This task must ONLY be done in an area
known to be non-hazardous.
y To access the 5566-CARRIER Non-Rechargeable Battery Carrier, unscrew the screw
located on the Battery Compartment Door on the base of the light.
NOTE: The Battery Compartment Door Screw utilizes a design that prevents the
screw from falling out of the door. Do not attempt to remove the screw.
y Open the Battery Compartment Door with enough clearance to allow the 5566-CARRIER
Non-Rechargeable Battery Carrier to slide out.
Installing or replacing the batteries
y Begin by positioning the 5566-CARRIER Non-Rechargeable Battery Carrier with the
arrow pointing to the left.
y Using 3 – AA Energizer EN91 or Energizer E91 (make sure that all 3 batteries are of
one or the other model...do not use a combination of the two), install the batteries per the
diagram located on the base of the battery carrier.
y Take care not to bend any of the battery contact springs, and to make sure that all 3
Ex ia op is I Ma
Ex ia op is IIC T4 Ga
(-20ºC ≤ Tamb ≤ +40ºC)
batteries are properly seated before installing into the angle light.
NCC 18.0110 X
NOTE: The battery carrier cover will only fit one way. It is not possible to install it in
a reversed position.
The Nightstick 5566-CARRIER Non-Rechargeable Battery Carrier is ready to install into
the Angle Light. Installation of the 5566-CARRIER Non-Rechargeable Battery Carrier into the
Angle Light is the same as installing the 5568-BATT Lithium-ion Battery Pack. Please see the
instructions listed above in the 5568-BATT Lithium-Ion Rechargeable Battery Pack section.
Installing the Non-Rechargeable Battery Carrier
y With the Battery Compartment Door opened enough to provide clearance, insert the
5566-CARRIER Non-Rechargeable Battery Carrier with the end having the metal contacts
on it being inserted first.
y With the battery carrier fully inserted into the handle of the light, close the Battery
Compartment Door and secure it in place with the Battery Compartment Door Screw.
WARNING: Do not over-tighten the Battery Compartment Door Screw.
OPERATION
THE XPP-5566 HAS 8 SEPARATE LIGHTING MODES:
Flashlight Modes
To activate the Flashlight, press and release the Flashlight Switch. The default mode
will be High-brightness. To select the brightness level for the Flashlight, press and hold
the Flashlight Switch. The flashlight will cycle from high to medium to low at a rate of
approximately one mode per second. The light will continue to cycle through the various
modes as long as the switch is held down. When the desired brightness level is reached,
release the Flashlight Switch and the light will remain in that brightness mode. To turn the
Flashlight off, press and release the Flashlight Switch one more time.
Strobe
To activate the Strobe, double click the Flashlight Switch. To turn the Strobe off, press
and release the Flashlight Switch one more time.
Floodlight Modes
To activate the Floodlight, press and release the Floodlight Switch. The default mode
will be High-brightness. To select the brightness level for the Floodlight, press and hold
the Floodlight Switch. The floodlight will cycle from high to medium to survival at a rate of
approximately one mode per second. The light will continue to cycle through the various
modes as long as the switch is held down. When the desired brightness level is reached,
release the Floodlight Switch and the light will remain in that brightness mode. To turn the
Floodlight off, press and release the Floodlight Switch one more time.
Dual-Light Mode
Dual-Light mode allows the user to turn on both the Flashlight and the Floodlight at the
same time. Dual-Light mode can be activated by simply pressing the Flashlight Switch and
then the Floodlight Switch at the same time. If the Angle Light already has the Flashlight or the
Floodlight on (regardless of what brightness mode that light is in), pressing the switch for the
light that is NOT on, will activate Dual-Light mode. The user can leave Dual-Light mode and
go back to either Flashlight or Floodlight mode simply by pressing the switch for the mode that
they wish to turn off. To turn both lights off, simply press each of the switches independently.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and
materials for the original purchaser's lifetime. The Limited Lifetime Warranty includes the
LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics and
included accessories are warranted for a period of two years with proof of purchase. Normal
wear and failures which are caused by accidents, misuse, abuse, faulty installation and
lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or fitness for
a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/nightstick-product-
support/warranties. Retain your receipt for proof of purchase.
INS-XPP-5566-DL-22
09-09-2022