Descargar Imprimir esta página

Broan Elite EWP1306SS Manual Del Usuario página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

6" ROUND
STEEL DUCT
DUCT LENGTH
DECORATIVE
FLUE
7. Measure and install 6" round steel ductwork to the blower
exhaust opening on top of hood. Use duct tape to make all
joints secure and air tight.
8. Hold hood up close to wall mounting location and plug
power cord into wall outlet.
9. Align the hood and center it above the hood mounting
bracket. Make sure ductwork on hood lines up and attaches
to ductwork in ceiling. Gently lower the hood until it securely
engages the bracket.
10. Use duct tape to make all joints secure and air tight.
INSIDE BACK OF HOOD
SIDE VIEW
HOLES LOCATION
11. With the hood hanging in place, drill through both holes
located in the inside lower back of hood using a 5/16" drill
bit. Insert the included drywall anchors into the drilled holes
(one for each hole). Install (2) washers and (2) no. 8 x 1½"
mounting screws through the hood back and into the drywall
anchors. Verify that the hood is centered and leveled. Tighten
all screws completely.
12. Reinstall grease filters by aligning rear filter tabs with slots
in the hood. Pull down the metal latch tab, push filter into
position and release. Make sure filters are securely engaged
after installation.
13. Slightly push aside the upper flue to avoid any damage
while installing the lower flue to the hood top. Secure the
lower flue bracket to the wall using (2) no. 8 x 1½" mounting
screws.
MOTOR/BLOWER
ASSEMBLY
Ø 5/16" TYP.
MODELS EWP1306SS • EWP1366SS
UPPER FLUE MOUNTING BRACKET
UPPER
FLUE
14. Slide the upper flue upward until it is aligned with its upper
flue mounting bracket. The bracket should be inside the flue.
Secure the upper flue to the upper flue mounting bracket
using (2) no. 8 x 3/8" mounting screws.
15. Remove protective plastic film covering the upper flue and
the hood.
HO0366
INSTALL THE HOOD
(Non-Ducted Hoods Only)
NON-DUCT KIT MODEL ARKBWP CONTENTS
NON-DUCT
8 MOUNTING
PLENUM
SCREWS
(ST4 x 8
Round Head)
NON-DUCT PLENUM
COLLAR
NOTE: Non-ducted installations require Non-Duct Kit,
HR0229A
model ARKBWP (purchase separately).
1. CAUTION: Use only flexible duct provided.
2. Do not remove the protective plastic film covering the
decorative flue and the hood at this time.
3. Lay the back side of the hood flat on a table. Use a piece
of cardboard to avoid damaging the table or the hood.
Page 8
NON-DUCTED
RECIRCULATION
FILTERS
2 TIE
WRAPS
FLEXIBLE DUCT

Publicidad

loading

Este manual también es adecuado para:

Ewp1366ss