Publicidad
Idiomas disponibles
Idiomas disponibles
Spool
cover
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
Hole
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap counterclockwise to wind the cutting
line into the trimmer head. Keep approximately 5 in of
cutting line on each side of the trimmer head.
10.5
REPLACE THE BUMP KNOB
1. Push the tabs on the sides of the trimmer head at the same
time.
English
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and firmly pull it out.
Bump
head
5. Put the new bump knob onto the spool.
11
Remove the battery pack from the machine before
transportation and storage.
11.1
When you move the machine, you must:
•
Stop the machine.
•
Remove the battery pack.
11.2
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the machine.
•
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
•
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
11
TRANSPORTATION AND
STORAGE
WARNING
MOVE THE MACHINE
STORE THE MACHINE
EN
Publicidad
