Publicidad
Idiomas disponibles
Idiomas disponibles
8
INSTALLATION
8.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
•
If parts of the machine are damaged, do not use the
machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.2
ATTACH THE EDGE GUIDE
The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Insert the edge guide into the two holes on the housing
for fitment.
2. The edge guide can be flipped up for storage.
NOTE
English
8.3
ATTACH THE GUARD
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
8.4
ASSEMBLE THE SHAFT
1. Loosen the hex screw on the coupler (8).
2. Push in the release button (14) on the lower shaft (9).
3. Align the release button with the positioning hole (15)
and slide the two shafts together.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the allen key (13).
7
WARNING
EN
Publicidad
