Publicidad
Idiomas disponibles
Idiomas disponibles
To control a DVD player:
Program the remote
control to recognize the
brand of your DVD
player (see
"Programming the
remote control to
operate your other
devices" below). The
buttons shown at right
will then control the
DVD player.
Press "DVD" first.
Programming the remote control to operate
your other devices
This remote control is pre-programmed to operate most Toshiba
satellite receivers, VCRs, and DVD players. To control a non-Toshiba
device (or a Toshiba device that the remote control is not pre-programmed
to operate), you must follow the steps below to program your remote control.
1.
Refer to the device code tables (on pages 16 and 17) to find the
corresponding code for your device.
If more than one code is listed, try each one separately until you
find the one that works.
2.
If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Press "CBL/SAT."
• VCR: Press "VCR."
• DVD player: Press "DVD."
3.
While holding down RECALL, press the Channel Number buttons
to enter the three-digit code for your device within 10 seconds.
Note: If you do not enter the code within 10 seconds from step 3,
or if you enter the wrong code, this operation is canceled.
4.
Point the remote control at the device and press POWER to test
the code.
• If the device responds, you entered the correct code.
• If the device does not respond, repeat steps 1–4 using another code.
5.
Press "TV" to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code _____________________
VCR code ______________________________________________
DVD player code _________________________________________
3Y90121A(E)_P14-21
15
Power
Input (TV)
Recall
Mute (TV)
Number
buttons
Volume +/– (TV)
DVD
Pic Size (TV)
DVD MENU
▲▼
ENTER
DVD controls
DVD Skip/Search
/
TOP Menu
DVD Clear
Note:
• When shipped from the factory, the remote
control is set to operate your TV.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
15
4/6/06, 3:12 PM
Recall
Channel
Numbers
TV
VCR
DVD
CBL/SAT
Publicidad
