Publicidad
Idiomas disponibles
Idiomas disponibles
Auto power off
The TV will automatically turn off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its
broadcast for the day and stops broadcasting on that channel. This feature does not work in VIDEO mode.
Understanding the Power Return feature
If the power is cut off while you are viewing the TV and the power is resupplied, the Power Return feature will turn the TV
on automatically. If the power is going to be off for a long time or you are going to be away from the TV for a long time,
unplug the power cord from the wall outlet to prevent the TV from turning on in your absence.
Appendix
Troubleshooting
Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions.
Symptom
Black box on screen
TV will not turn on
No picture, no sound
No sound, picture OK
Poor sound, picture OK
Poor picture, sound OK
Poor reception of broadcast channels
Cannot receive above channel 13
Unable to select a certain channel
Cannot access signal input sources (Video1,
Video2 and ColorStream and/or Channels 3 and 4)
Multiple images
Poor color or no color
No stereo or SAP sound from a
known MTS broadcast
The V-Chip password does not work
(U.S. V-Chip system only)
The remote control does not operate
The front panel buttons do not operate
Digital broadcasting screen problem
Closed Caption box appears with no text
3Y90121A(E)_P32-Back
37
Solution
• Select OFF in the Closed Caption menu to turn off the Closed Caption Text mode.
• If you connected a high-definition receiver, 480p progressive scan DVD player, or
other similar device to this TV, you must switch the device's output to 480i interlaced
mode first. Failure to do this will display the word "ColorStream" on a black screen.
• Make sure the power cord is plugged in, then press POWER.
• The remote control batteries may be dead. Replace the batteries.
• Check the antenna/cable connections.
• The sound may be muted. Press VOLUME.
• The station may have broadcast difficulties. Try another channel.
• The MTS feature may be in SAP mode. Select STR or MONO in the MTS menu.
• The station may have broadcast difficulties. Try another channel.
• The MTS feature may be in SAP mode. Select STR or MONO in the MTS menu.
• Check the antenna connections.
• The station may have broadcast difficulties. Try another channel.
• Adjust the PICTURE menu.
• The station may have broadcast difficulties. Try another channel.
• Check the antenna connections.
• If you are using a video input, make sure the TV/VIDEO button is set correctly.
• Make sure the TV/CABLE feature in the SETUP menu is set to "CABLE."
• The channel may be blocked by the V-Chip feature or CH LOCK feature, or erased
with the add/erase feature.
• Check the VIDEO LOCK feature.
• The station may have broadcast difficulties. Try another channel.
• Use a highly directional outdoor antenna.
• The station may have broadcast difficulties. Try another channel.
• Adjust the TINT and/or COLOR in the PICTURE menu.
• If you change the direction of the TV while it is turned on, the picture could suffer
from color shading. If so, turn off the TV and allow it to cool for several hours before
turning it on again.
• Make sure the MTS feature (in the AUDIO menu) is set properly.
• Change or reset your password.
• Make sure the TV • CBL/SAT • VCR • DVD mode is set properly on the remote
control.
• Remove all obstructions between the remote control and the TV.
• The remote control batteries may be dead. Replace the batteries.
• Check the FRONT PANEL LOCK feature.
• Check the digital signal strength.
• Make sure the Closed Caption "Text Color" and "Background Color" are not set to
the same color (see page 32).
37
4/6/06, 3:14 PM
Publicidad
