LG WD200C Serie Manual Del Propietário página 27

BEFORE CALLING FOR SERVICE (continued)
Problem
Wrinkling Washer not unloaded promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Excessive sudsing Too much detergent or incorrect
detergent.
Staining Bleach or softener was added di-
rectly to the wash load in the tub.
Washer was not unloaded promptly.
Clothes were not properly sorted. Always wash dark colors separately from light colors and
Washer will not turn Power cord is not properly plugged
ON in.
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred.
NOTE: If the washer stopped during a cycle due to a loss of power, the washer will resume
the cycle where it stopped when the power is restored.
Wash cycle time is lon- The washer automatically adjusts
ger than usual the wash time for the amount of
laundry, water pressure and other
operating conditions.
Musty or mildewy odor Incorrect or too much detergent
in washer has been used.
Inside of tub was not cleaned prop-
erly.
Water leaks Oversudsing of detergent.
Possible Cause Solutions
Always remove items from the washer as soon as the
cycle is complete.
The washer can be fully loaded, but the tub should not be
tightly packed with items. The lid of the washer should
close easily.
Hot water rinse can set wrinkles in garments. Check the
inlet hose connections.
HE detergents are formulated specifically for High-Effi-
ciency washers and contain suds-reducing agents. Only
use detergent with the High-Efficiency (HE) logo. For
detergent quantities refer to the How to Use section. If
sudsing or detergent residue continue to be an issue, add
an Extra Rinse.
Always remove items from the washer as soon as pos-
sible after the cycle is complete.
whites to prevent discoloration.
Never wash heavily soiled items washed with lightly
soiled items.
Make sure that the plug is plugged securely into a ground-
ed, 3-prong, 120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
This is normal. The washer adjusts cycle time automati-
cally to provide optimal results for the selected cycle. The
time remaining shown in the display is only an estimate.
Actual time may vary.
Use only High-Efficiency (HE) detergent in accordance
with the manufacturer's instructions. This machine re-
quires very little detergent. 1-2 teaspoons is sufficient to
wash a full load.
Run the Tub clean cycle regularly.
Oversudsing may create leaks, and may be caused by the
type and amount of detergent used. High-Efficiency de-
tergent is the only detergent recommended. Always re-
duce the amount of detergent if the load is small or lightly
soiled, or if your water is very soft. Never use more than
the maximum amount shown in the dispenser provided.
TROUBLESHOOTING
27