Publicidad
Idiomas disponibles
Idiomas disponibles
I
NTRODUCTION
Supplied Accessories
pp
pp
owner's manual
(1EMN25921)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
Attaching the Stand
g
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least 2 people are required at this
step.
Unscrew the Phillips pan screws on step 3.
After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
Symbols Used in this Manual
y
The following is the description for the symbols used in this manual. Description refers to:
TV FUNCTIONS
: Analog TV operation
TV
: Digital TV operation
DTV
• If neither symbol appears under the function heading,
operation is applicable to both.
4 4
EN
quick start guide
remote control
(1EMN25922)
(NF033UD)
2
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow
the stand in the direction as shown
by arrow
➁
mounting holes are aligned.
Make sure not to put the AC power
cord between the stand and the unit.
➁
registration card
(1EMN24700)
b
batteries
(A A A, 1.5V x 2)
AA, 1.5V x 2)
3
), then slide
➀
until it stops and the
➀
DVD FUNCTIONS
: Playback of DVD-video
DVD
: Playback of audio CD
CD
• If neither symbol appears under the function heading,
operation is applicable to both.
screw kit for
attaching the stand
(1ESA19508)
Drive Phillips pan screws in
threaded holes at the bottom of the
stand until they are tight.
Publicidad
