Ryobi P330 Manual Del Operador página 10

SINGLE SEQUENTIAL ACTUATION MODE
Single sequential actuation provides the most accurate
fastener placement.
 Remove battery pack from the tool.
 Slide the selector to position ( ).
WARNING:
The nailer will not function properly if the selector
is not securely seated in either position ( ) or
( ). Always assure the selector is seated properly to
avoid an unexpected nail discharge and possible serious
personal injury.
 Reinstall the battery pack.
 Grip the tool firmly to maintain control. Position the nose
of the tool onto the work surface.
 Push the tool against the work surface to depress the
workpiece contact.
 Squeeze the trigger to drive a fastener.
NOTE: Hold trigger until drive cycle is complete. If depressing
the trigger does not drive a fastener, lift the tool away from
the workpiece, then replace and try driving the fastener again.
CONTACT ACTUATION MODE
Contact actuation allows very fast repetitive fastener
placement.
 Remove the battery pack from the tool.
 Slide the selector to position (
 Reinstall the battery pack.
 Grip the tool firmly to maintain control.
 Squeeze and hold the trigger. Push the tool against the
work surface to depress the workpiece contact and drive
a nail.
NOTE: Hold trigger and keep workpiece contact
depressed until drive cycle is complete.
 Always remove your finger from the trigger when the
desired number of nails has been driven.
NOTE: In Contact Actuation Mode, the tool may also be
operated by depressing the workpiece contact against the
surface and squeezing the trigger.
WARNING:
During normal use the tool will recoil immediately
after driving a fastener. This is a normal function of the
tool. Do not attempt to prevent the recoil by holding the
nailer against the work. Restriction to the recoil can result
in a second fastener being driven from the nailer. Failure
to heed this warning can result in serious personal injury.
OPERATION
).
10 — English
DRY-FIRE LOCKOUT
When the magazine has 0-5 nails remaining, the dry-fire
lockout feature will not allow continued operation.
To resume operation, reload the tool with nails.
LED WORKLIGHT
See Figure 10, page 15.
 To turn on the LEDs, press LED worklight grip switch
while firmly holding tool during normal operation.
DIAGNOSTIC FEEDBACK
The LED Worklight provides feedback to indicate whether
the battery pack is charged sufficiently and/or if the tool is
functioning properly.
If worklight is flashing, install fully charged battery. If light
continues to flash, see Troubleshooting section for more
information.
If the LED light goes out on your nailer, the unit has timed
out for your protection. Lift tool from the workpiece and
release trigger to reactivate the nailer before beginning next
drive cycle.
REMOVING NAILS FROM THE TOOL
See Figure 11, page 15.
WARNING:
Remove the battery pack before removing nails or
clearing a jammed nail. Failure to do so could result in
serious personal injury.
 To remove a strip of nails from the tool, hold the finish
nailer by the handle with your right hand, and rest your
left hand underneath the tool with your left thumb on the
pusher.
 Depress the release button and slide the pusher all the
way to the rear of the magazine until it locks in place.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
 Slide the nails toward the back of the magazine and
remove.