Publicidad
Idiomas disponibles
Idiomas disponibles
us_main.book.book Page 16 Thursday, June 9, 2022 1:51 PM
16 INSTALLATION
WARNING
• Do not use an adapter or extension cord. Doing
so may result in serious injury, fire, electric
shock, or death.
• For best performance, plug the appliance into its
own individual outlet. This helps prevent
overloading house wiring circuits which could
cause a fire hazard from overheated wires.
• If necessary, use a new, UL-listed extension cord
with a 3-prong (grounding) plug rated at no less
than the branch circuit. Do not use an extension
cord longer than 3 feet. Failure to follow these
warnings may result in serious injury, fire,
electric shock, or death.
Testing the Washer
Check if the washer is properly installed and run a
test cycle.
1
Load the washer with 6 thick bath towels
(approximately 6 pounds).
2
Press the Power button.
3
Turn the knob and select the Quick Wash
cycle.
4
Press the Start/Pause button to start the
wash cycle.
5
Make sure that water is supplied, that the
washer does not rock or vibrate excessively,
and that it drains well during the spin cycle.
NOTE
• If water leaks during water supply, see
Connecting the Water Inlet Hoses to connect
them properly.
• If the washer rocks and vibrates excessively, see
Leveling the Washer to level it again.
• If the drain does not work, see Connecting the
Drain Hose to install the hose properly.
Publicidad
