Control Panel; Sleep Function - Resfriar S7i Manual Del Propietário

2. Control Panel

R7i Model:
• SLEEP FUNCTION: Turn on the fan (8), then the red led (4) is
continuously on to inform fan is in operation but the sleep is still without
programming. Press the sleep button (6) so the led (4) will blink once to
inform the sleep is programmed for one hour. If you want to program
more than one hour, keep pressing button (6) up to five (five hours). Led
will blink corresponding to the number of hours programmed. To turn
off the sleep function, you should press button (6) until the led (4) doesn't
blink anymore or you can turn off the fan by pressing button (7).
Note: When turning off the fan by pressing button (7), the sleep
programming will be off automatically.
2
1
5 6 7
8
6 4
6
6
7
3 4
5
Not for R7i
2
command
6
Not for R7i
command
Remote Control
Functions
8
• WATER FUNCTION: To turn on/off the water function (ventilation
with cooling process) press button (5). The green led (3) will lights
showing the function is on. If the green led (3) is continuously on, it
means that the water function is in operation, but the injection pump
4
is not working. Green led (3) blinking means that water function is
operating and the injection pump is working too.
Note: When the fan starts, water function starts working
automatically.
4
7
Control Panel / Remote Control Functions
1 - Remote control IR receiver
8
2 - Lack of water signal lamp (yellow)
3 - Water injection on signal lamp (green)
9
4 - Sleep on signal lamp
7
5 - On/Off water injection
Not for R7i
command
6 - Sleep programming
7 - Off /Decrease fan speed
8 - On/Increase fan speed
9 - On/off fan (function only in the remote control)
5
3
3
3
17