Perel LEDA7001NW-BP Manual Del Usuario página 3

LEDA7001NW-BP/LEDA7002NW-BP/LEDA7003NW-BP/LEDA7005NW-BP
3. General Guidelines

Refer to the Velleman
manual.

All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.

Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.

Keep this manual for future reference.
4. Installation
Guidelines

The construction to which the device is attached should be able to support 4 times
the weight of the device for one hour without deformation.

Never stand directly below the device when it is being mounted, removed or
serviced. Have a qualified technician check the device once a year and once before
you bring it into service.

Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack
these qualifications as improper installation may result in serious injuries.

This device is not suitable for dimming.
Distances

Keep at least 20 cm distance at the top and 30 cm on either side.

Respect a minimum distance of 1 m between the device's light output and any
illuminated surface.
Location

You can adjust the detection area according to your needs: turn the device to the
left or right and aim it up or down. Note that the detector is much more sensitive to
objects moving across the detection area than it is to objects coming straight at it.
This is a very important consideration when selecting the mounting location.

Please avoid installing the floodlight upside-down in order to ensure its
watertightness.

The floodlight should be fixed to a stable outdoor wall made of a non-flammable
material approximately between 0.5-3.0 m above the ground and at an angle of
± 60°, preferably in a location under eaves where the unit is protected from the
elements and shielded from direct sunlight.

Do not block the front of the detection window and make sure the detection area
holds no moving objects.

Do not install the device close to air conditioning vents, radiators, etc.
V. 01 – 05/12/2018
®
Service and Quality Warranty on the last pages of this
3 ©Velleman nv