Orbegozo CP 77132 Manual De Instrucciones página 13

CP 77132 CP 87132
BLADE ATTACHMENT
Note: Before installing the fan, you need to attach the blades onto the motor.
1. Insert the blade through the slot on the centre band. Align holes and fasten the blade to the motor
with provided screws. Repeat this procedure for remaining blades. After all the blades are securely
fastened to the motor, push the top housing down on the motor and fasten the top fan housing with
screws (figure 5A)
2. Put the light base onto the con connecting board, then revolve it clockwise, and fasten it by screws
(figure 5B) (For model with lamp)
Warning: Make sure all screws are tightened securely. Use the lock washers provided.
INSTALLING LIGHT KIT
1. The light kit filter is pre-installed and no additional wiring is required.
2. Install one 40 W E27 bulb, screwing it clockwise into the bulb socket.
3. Raise the glass shade up against bottom of the fan housing and secure it to the fan by twisting the
glass clockwise until it is snug. Do not over tighten as the glass may crack under excessive pressure.
4. Raise the metal cover up against bottom of the fan housing and secure it to the fan by twisting the
cover clockwise until it is snug.
5. Restore power to your fan and your light kit is ready to operate.
ELECTRICAL CONNECTION
OPERATING YOUR FAN
13