Publicidad
Idiomas disponibles
Idiomas disponibles
CP 77132 CP 87132
- Select the fan speed by pressing the speed control button on the remote control transmitter :
HI: High Speed MED : Medium Speed LOW : Low Speed
- The switch on motor housing for controlling the fan blades rotating direction controls the direction of
air movement.
- Caution : Before using this rotating direction switch, turn OFF the fan and ensure the fan stops rotating
to prevent injury to yourself and damage to the moto.
- Cold weather: Push the switch 'UP' so that the blades will bring the warm air trapped near the ceiling
fan to move downwards throughout the room.
- Hot weather: Push switch 'DOWN' so that the blades will create a breeze and circulate the air to the
room.
- Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning on or off
of the light.
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch the light and fan on or
off.
- Replace the batteries by sliding the battery compartment cover on the remote control transmitter in
the direction of the arrow, fit 2 x 'AAA' batteries, and ensure the polarity of the batteries match with
the figures shown in the battery compartment. (Note : Batteries NOT included).Re-assemble the battery
compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired batteries. There are special rechargeable batteries, which are clearly
marked with.
- Don't dispose of batteries in fire to avoid explosion.
TRANSMITTER OPERATION:
Point the remote at the infrared sensor to power the fan.
HI:
turn on the fan at high speed.
MED: turn on the fan at medium speed.
LOW: turn on the fan at low speed.
OFF:
turn off the fan at low speed.
LIGHT :ON/OFF –press and release immeditaly to turn on or off the light.
1H, 2H, 4H: program operation of the fan (but not light) 1 hour, 2 hours and 4
hours respectively. to do this, then operate the fan and press one of these 3
buttons, and after the selected time, the fan stops working (note: light can
not be programmed).
OFF :
Off
14
Publicidad
