Garland MULE 661 E Manual De Instrucciones página 28

English
6. START UP INSTRUCTIONS
6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Engine.
• Botton handle.
• Top handle.
• Screw M6x45 (x4).
• Wing nut M6 (x6).
• Screw M6x30 (x2).
• Clip screw (x2).
• Clip (x2).
• Cable extension holde.
• Spur.
• Instruction manual.
6.2. MOUNTING
6.2.1. BOTTOM HANDLE
Attach the bottom handle (1) by inserting it on the
bottom tubes of the machine (2) and use the screws
(4) and wing nuts (5) provided to attach the handle to
the machine.
Place the coupling cable (3) through the bottom
handle.
6.2.2. TOP HANDLE
Use the screws (4) and wing nut (5) to hold top handle
to the bottom handle.
Use the two clips (6) to hold the cable.
6.2.3. INSTALLATION OF THE ON/OFF SWITCH
2x
Spur
6.3. CHECKING POINTS PRIOR TO USING THE
MACHINE
The current and tension supplied must coincide
with those in the characteristics label. Prior
to starting work check that the machine works
adequately and all security measures work.
Check the machine and look for any loose pieces
(screws, nuts, housing etc) and for any damages.
Tighten, repair or replace those pieces that you have
found to be in a bad state. Ensure that there are no
leakages. Do not use the machine if damaged or not
well regulated.
28/112
2x
M6x30