CASO DESIGN HW 550 Manual De Instrucciones página 30

14.2 Use
1. Fill the watertank with water, you can remove it to do this.
2. Place your cup on the removable drip tray, make sure it aligns with the spout.
3. First press
4. Press Temp-button to choose your desired temperature and press
button to set the water volume.
5. Press Start/Stop-button to start the device. The desired water volume will flow out from
water spout. Press Start/Stop-button again, to stop the device.
6. If you want to dispense water again, repeat the steps above.
► We recommend preheating the cup (especially with low volume settings) in order to avoid
a loss of temperature.
► If the device was not used for longer time there could be scale deposits. In this case let
100 ml with 100 °C run through the device or descale the device as described under
"Cleaning and Maintenance".
► The ambient temperature and the level in the water tank affect the amount of water
dispensed. It can vary up to +- 15%.
► Do not fill milk into the device.
14.2.1 Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the device by one
hand and use the other hand to lift up the drip tray slightly to
remove it.
2. Empty the drip tray and insert it into the original place. Make
sure it is properly inserted.
You can use the device without a drip tray if you want to place a
taller cup under the water outlet. To do this, remove the drip tray
and place the cup central under the water outlet.
Warning
The device can continue to run for a short time after the water has been dispensed.
If the device is operated without a drip tray, there is an increased risk of burns!
► Only remove the cup after the device has stopped dripping.
14.2.2 Error code Lo
If the device stops to operate with a beeping sound and the display shows the error code Lo,
it means that there is too little water or no water in the water tank. Please fill in enough water
into the water tank immediately.
Lock-button about 3-5 seconds for unlocking the device.
Please note
Volume-
30