Publicidad
T EC HN I C A L I N FO RMATIO N
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate
Flow rate - boost setting
Flow rate - bidet
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ Please inspect the faucet for shipping damage be-
fore installation. Hansgrohe will not honor claims for
shipping damage after the faucet is installed.
⁄ For best results, the water pressure of the hot and
cold water supplies should be equal.
TOOLS R E Q UI RE D / OU TI L ES U TI L E S /
H E RRA M IE N TA S ÚT I LE S
2
15 - 75 PSI
120° - 140° F*
0.9 GPM
1.2 GPM
2.2 GPM
10 mm
19 mm
E N G L I S H
145 PSI
176°F*
1⅜"
1⅝"
⁄ The check valves should be inspected yearly, and
replaced if dirty or worn.
⁄ Model #12210xx1 only: The discharge water
temperature from a bidet fitting shall be limited to a
maximum temperature of 110ºF (43ºC) by a water
temperature limiting device conforming to ASSE
1070.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
