EGAmaster 79610 Manual De Instrucciones página 28

When connecting the machine, pay attention that the valve trigger 1 (see fig. 3) is not
actuated.
Blow out the pneumatic hose bevor connecting the machine. Never connect a pneumatic
hose being under pressure (see safety instructions for prevention of hazards caused by
compressed air).
First connect the machine and then connect the compressed air supply.
Prior to starting the machine put the reverse slide for rotation direction left and right into the
correct position.
For example, if you want to loosen a screw and the rotation direction is adjusted to a position
for screwing in, this can lead to violent uncontrolled movement of the pneumatic impact wrench.
Setting the rotation direction
The rotation direction is set with the reverse slide 2 (see fig. 4).
Actuate the reverse slide only when the pneumatic impact wrench is switched off.
Rotation direction right: For screwing-in of screws and nuts turn the reverse slide
clockwise, F.
Rotation direction left: For unscrewing of screws and nuts turn the reverse slide
anticlockwise, R.
The air regulator (power adjustment) is only for adjusting the output of the impact wrench, not
for the adjustment of a constant torque (see fig. 5).
Remark: The required torque adjustment and the duration of the screwing process are
depended on the type of screw connection. Ideally, this can be found out in practice.
Put the power socket wrench solidly and correctly on the screw head or the nut and start the
pneumatic impact wrench (see fig. 6).
28
STARTUP
1
Fig.3
2
R
F
Fig.4