Publicidad
Idiomas disponibles
Idiomas disponibles
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500 W (+5% –10%)
• Working voltage: 120v AC/60Hz
MAXFLOW
HEATING SYSTEM
TM
The patented MaxFlow
TM
top mounted fan and internal shroud to provide
maximum heat dispersion. The MaxFlow
delivers a combination of instant, penetrating warmth in
the immediate area, as well as forcing heat out for entire
room coverage.
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is in the Off ( I/O ) position
before plugging the heater into the outlet.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500
Watts, this unit draws 12.5 Amps.
NOTE: You may notice vibration/noise coming from the
grill and the interior quartz tubes when the heater is
turned on. PLEASE NOTE THAT THIS IS NORMAL AND SAFE
OPERATION. Once the quartz heating element has
warmed up, the vibration/noise will go away.
Mode Control
Turn the Mode Control to the desired setting:
I/O - Off Mode
If you want to shut off the heater at any time of
operation, turn the Mode Control to Off ( I/O ) position.
Power Light may remain lit until the heater is unplugged.
1 - Low Heat
The heater will run continuously at 750W.
2 - High Heat
The heater will run continuously at 1500W.
Thermostat Control
1. Before setting the thermostat, allow heater to operate
and warm up the room. You need to turn the
Heating system incorporates a
Heating system
TM
Thermostat Control clockwise to the highest setting
( Largest
) to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the heater
stops operating. This is done by moving the
Thermostat Control counter-clockwise toward the Low
( Smallest ) setting.
Figure 1
Thermostat
Figure 2
Power Light
1-Low (750 Watts)
Thermostat
Power Light
Mode Control
2-High (1500 Watts)
OFF
Mode Control
Publicidad
