Publicidad
Idiomas disponibles
Idiomas disponibles
F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
3. The control will now automatically maintain the
pre-set temperature level by turning the heater ON
and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, raise the thermostat to the highest setting.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN
OPERATION.
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and allow the
heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild
soap solution.
2. NEVER use abrasive or flammable solvents to clean
the unit.
3. After cleaning, be sure to completely dry the unit
with a cloth or towel.
TIP: Over time, dust may accumulate on the front
grills. This can be removed by wiping the unit with a
damp cloth.
AUTO SAFETY SHUT-OFF WITH INSTANT
TIP OVER PROTECTION
This heater is equipped with a technologically-advanced
safety system that requires the user to reset the heater if
there is a potential overheat situation. When a potential
overheat temperature is reached, the system will
automatically shut the heater off. It can only resume
operation when the user resets the unit. For specific reset
instructions please refer to the unit.
RESET INSTRUCTIONS
If your heater shuts down:
1) Turn Control to OFF.
2) Unplug the unit and wait 30 minutes.
3) Plug in and operate normally.
Tip Over Shut-Off:
When the unit is accidentally knocked over, it will
instantly shut off. The unit may also shut off if it is
moved or bumped. To reset, simply place the heater in an
upright position and it will operate normally.
NOTE: If unit does not turn on when placed in the
upright position, turn the Mode Control to High (2) setting
and heater will resume operation.
TROUBLESHOOTING
If your heater fails to operate:
• The thermostat might be set too low. Turn the
Thermostat Control clockwise until the heater restarts.
• Make sure Mode Control is in Low (1) or High (2)
setting.
• UNPLUG THE UNIT and make sure the heater is
placed in an upright position.
• Make sure the electrical outlet or circuit breaker is
working.
• Check for obstructions. If you find an obstruction turn
the heater OFF, and unplug the unit. Carefully
remove the obstruction and follow the reset
instructions.
Please DO NOT attempt to open or repair the
heater.
HEATER STORAGE
1. Store heater unit with cord in a cool, dry location.
2. We recommend storing the unit and cord in the
original package.
If you have any questions regarding your product or
would like to learn more about other Holmes
please visit our website at www.holmesproducts.com.
For inquiries regarding recycling and proper disposal of
this product, please contact your local waste
management facility.
products,
®
Publicidad
