Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
If there is a jam in the appliance
This means that you may have attempted to feed too much paper into the appli-
ance (max. 10 sheets 80 g/m
♦
Move the REV/OFF/AUTO/FWD switch
causes a blockage. The appliance now goes into reverse and the material is
ejected.
♦
Alternatively, move the REV/OFF/AUTO/FWD switch
position if the paper causes a blockage. The appliance is now in forwards
operation and the material that is being shredded is pulled in again.
♦
Pull the paper out of the appliance and then move the REV/OFF/AUTO/
FWD switch
The appliance is now ready for use again.
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated itself. The overheat lamp
♦
Move the REV/OFF/AUTO/FWD switch
♦
Remove the plug
♦
Allow the appliance to cool down for about 30 minutes.
♦
Replace the plug
♦
Switch the appliance on by moving the REV/OFF/AUTO/FWD switch
to the AUTO position. The power lamp
The overheat lamp
sufficiently.
If the appliance cannot be switched on
♦
Make sure the cutter attachment
collector
♦
Try a different socket.
♦
The appliance is possibly defective. Have the appliance checked by a
qualified technician.
♦
The appliance has overheated and triggered the automatic safety cut-out.
Proceed as described in the section above If the appliance suddenly stops
working.
UAV 300 A1
2
paper).
3
to AUTO.
1
from the mains power socket.
1
in the mains power socket.
5
remains off when the appliance has cooled down
w
.
3
to the REV position if the paper
3
5
lights up permanently red.
3
to the OFF position.
4
lights up permanently blue.
6
is seated correctly on the large waste
to the FWD
3
GB │ IE
11
│
■
Publicidad
