Reverse Stitch Lever; Sewing Light; Replacing The Presser Foot - Easy Home MD 17922 Manual Del Usuario

Replacing the presser foot

Reverse stitch lever

When reverse stitching, turn the thread tension dial to "9" to
increase the tension on the upper thread. Turn the thread
tension dial back to the preselected setting when you have
finished reverse stitching.
Reverse sewing (back stitching) is useful for reinforcing the beginning and end
of seams.
1. Sew forwards as normal, and then press and hold down the reverse stitch
lever 4 to sew backwards.
2. To sew forward again, simply release the reverse stitch lever.

Sewing light

− If additional light is needed, press the light button
(see Fig. G).
− Press the light button again to turn it off.
Replacing the presser foot
CAUTION!
Risk of injury!
Improper handling of the sewing machine may result in injury.
− Always unplug the sewing machine, disconnect the foot
pedal, remove the batteries, and make sure the power
OFF/speed switch is set to "OFF" before replacing the
presser foot.
1. Unplug the sewing machine, disconnect the foot pedal
sure the power OFF/speed switch
2. Place the sewing machine on a flat and level surface.
3. Turn the handwheel
counterclockwise to
raise the needle to its
highest position.
26
6
3
9 to turn the light on
is set to "OFF."
29 , and make