GE PGS930 Manual Del Propietário página 26

Oven Light
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
WARNING
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
Before replacing the bulb, disconnect electrical power to
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To remove:
tabs of the glass cover clear the grooves of the socket
and pull the cover off. Remove the bulb.
To replace:
the glass cover into the grooves of the socket. Turn the
Oven Door
The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.
To Remove the Door:
frame to the unlocked position.
3. Firmly grasp both sides of the door near the top.
4. Close door until the top of the door is approximately
6" from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
2. With the door at the same angle as the removal
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
down to the locked position.
5. Close the oven door.
26
NOTE:
bulb is smaller than
household bulb.
Reconnect electrical
power to the oven once
the new bulb is installed.
For improved lighting
inside the oven,
clean the glass cover
frequently using a wet
cloth. This should be
done when the oven is
completely cool.
Hinge arm
Bottom
edge of
slot
Notch
Rest notch on bottom edge
of hinge slot
Socket
3 "
2
Max
length
Bulb
Tab
Glass cover
Removal position
49-2000781 Rev. 4