GreenWorks STF407 Manual Del Operador página 7

8 INSTALLATION
8.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.2 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws (1) from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle (2) and lower clamp (3) on
the shaft.
1
3. Set the auxiliary handle in the most comfortable in use
position.
4. Tighten the screws.
2
English
8.3 ASSEMBLE THE SHAFT
1. Loosen the screw (1) on the coupler (2).
2. Push in the release button on the lower shaft (5).
3. Align the release button (3) with the positioning hole (4)
and slide the two shafts together.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw (1) with the Allen key .
8.4 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.5 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
3
7
2
3
4
5
1
WARNING
EN