Publicidad
Step 9
Step
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (G) and lay it over your unit.
Make equal margins along all four edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make
it "square".
Using your hammer, fasten the BACK (G) to your unit
å
using the NAILS (12).
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C) and SHELF (F).
With a hammer, gently tap four TACK GLIDES (19) into the
å
ENDS (A and B).
419636
These holes must line up over
the UPRIGHT (C) and SHELF (F).
G
A
www.sauder.com
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
12
NAIL
(40 used in this step)
B
19
Page 13
Publicidad
