Cameo CLF4T Manual De Usuario página 10

Idiomas disponibles

INSTALLATION

Thanks to its four plastic feet, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using the prein-

stalled mounting bracket (A) and a suitable crossbeam clamp (available as an accessory). Make sure that the spotlight is firmly attached and

secure it using a suitable safety cable on the designated location on the top of the spotlight (B). Use the lever screw (C) located on one side

to adjust the vertical radiation direction.

A distance of at least 0.1 m must be kept between objects or walls located beside, above and behind the spotlight; a distance of at least

0.5 m must be kept in front of the spotlight in the cone of light.

Important: Overhead mounting requires extensive experience, including the calculation of the load limit values of the installa-

tion material and regular safety inspection of all installation materials and spotlights. If you do not have these qualifications, do

not attempt to perform an installation yourself. Refer instead to a qualified professional.

INSTALLATION / DISASSEMBLY OF BARN DOOR AND FILTER FRAME / CLEANING OF LENSES

Separate the device completely from the power supply. To mount or dismount the barn door and filter frame, press the spring-loaded locking

bolt (D) of the holding device so that it folds upwards. Do not forget afterwards to return the retaining bracket back to the original position

so that the lock pins click back into their locked position. The barn door's retention arm and filter frame on the bottom of the spotlight

are equipped with a second securing device (E) so that an additional safety cable for the barn door is not required. Once the barn door is

mounted on the spotlight, move the lever (E) on the bottom retention arm so that it is positioned parallel to the spotlight. The latch (F) will

then stop the barn door from sliding out of the retention arm. Rotate the lever 90° to open the securing device. Use the safety cable provided

to secure the filter frame.

Clf4d F4 t F4 d F4