Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing hob
● Using an electrical cord, connect the hob according to electrical diagram provided.
● Remove dust from the worktop, insert hob into the opening and press in firmly.
Assembly of the gasket
*Depending on the model, the seal is already installed at the factory (fig.1)
If the seal has not been fitted at the factory, proceed as follows:
Before installing the hob in the cut-out worktop, the gasket is to be attached to the back
of the hob (pic. 2)
To do this, first peel off the protective film from the self-adhesive seal and glue the gasket
as close as possible to the outer edge of the hob (fig. 3,4).
1
Do not install the appliance without the
foam gasket.
Then turn the hob over insert it into the cut-out of the
furniture. Align the positioning symmetrically so that the
distances between the hob and the countertop is the
same on all sides. (fig. 5)
1
2
3
1 - Worktop
2 - Hob flange gasket
3 - Ceramic hob
2
5
3
U S Z
K L E
C Z E
L K A
J
4
41
Publicidad
