Publicidad
Idiomas disponibles
Idiomas disponibles
3. Turn the rear tube in the direction of the arrow until
the two tabs lock into the positions.
4. Align the hole on the front tube with the tab on the
rear tube.
5. Install the front tube onto the rear tube until the tab
lock into the position.
9.3
INSTALL THE BATTERY PACK
Figure 4.
WARNING
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
•
Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
9.4
REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
10
OPERATION
WARNING
Make sure the blower tube is in position before
operation.
10.1 START THE MACHINE
Figure 1
1. Pull the trigger to start the machine.
2. Push the trigger to increase the speed.
3. Release the trigger to decrease the speed.
10.2 STOP THE MACHINE
Figure 1
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.
English
10.3 OPERATION TIPS
•
Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
•
Use rakes and brooms to clear the unwanted
material before you blow.
•
Make the surfaces wet before you clear the
unwanted material in dusty conditions.
•
Look out for children, pets, open windows, and
cleaned cars during operation.
•
Clean the machine.
•
Discard the unwanted material when you complete
work.
11
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
11.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with
a vacuum cleaner.
•
Do not spray the air vent or put the air vent in
solvents.
•
Clean the housing and the plastic components with
a moist and soft cloth.
12
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
12.1 MOVE THE MACHINE
•
Only hold the machine with the handgrip.
7
CAUTION
CAUTION
WARNING
CAUTION
WARNING
EN
Publicidad
